Mackwagon

In Hayward, CA, I have for sure, the flywheel and a clutch ,and shifter linkage that I could ship out to you. By front Knuckles you mean the front spindles? or Front hub carriers. So the hub carrier, the front bearing, the front hub, and maybe the front brake rotor?? I have a set of those. I should also have the full motor and transmission mounts and the half shaft. No axles (just buy rebuilt or new ones from Autozone, it will be cheaper than buying used ones and paying for shipping.

I am selling off a honda civic race car (24 hours of lemons) either as a whole car or parting it out (on the 24 HoL forum). If I part it out, I will have the manual transmission and maybe the drive axles for sale.

I sent you a message directly, but I'll repost here also. I have the:

5spd 89 Integra complete shift linkage
5spd 89 Integra front tranny mount
5spd 89 intermediate shaft (you can buy new complete axles from a auto parts store)


89 Integra engine harness but I have to check on its condition

I can ship them from Hayward, CA to Bakersfield, CA

Jay,

I have an 89 Integra that I'm parting out (engine donor for a 1984 civic hatchback 24 Hours of Lemons car). I think I have the CV housing you need on one of our transmissions. Basically this is the inboard end of the CV joint, which usually is part of the passenger drive shaft(?). I'll take a picture tonight and get that sent to you.

Dan H.

I have the fronts from an 89 I'm parting out. Sent you a message

D,

I have a 89 integra that I'm parting out. I can get you these. I'm in California. How much money do you have???

Dan