Good idea. I was also thinking the same thing but with plastidip
How durable is plastidip? I also found that Plastidip doesn't clean very easily and given it is thicker, it might be difficult fitting.
14 June 2016 - 11:33 AM
Good idea. I was also thinking the same thing but with plastidip
How durable is plastidip? I also found that Plastidip doesn't clean very easily and given it is thicker, it might be difficult fitting.
09 May 2016 - 04:05 PM
I'll bet that was a bit of work. It does look really cool though!
Haha it certainly was. Build thread here: http://crxcommunity....hp?f=36&t=15743
08 May 2016 - 01:58 AM
I like it! What front end do you have on it? The pop up lights are cool!
Thanks, its head lights from an integra 1g. Took part of the hood to make the header panel and part of the fenders merged with the abs crx fenders to make the fenders. bumper is stock crx.
04 April 2016 - 04:56 PM
There is still work today but this picture is a month old.
Edit: I guess I should post pictures of the lights up too
Interior:
Full build thread can be found here:
23 March 2016 - 05:24 PM
Question! Since we both went with tucking our radiator filler necks, I recently discovered that the K-series actually fill their coolant via a filler neck that is attached to the head. I found that some aftermarket actually make this for the K-series and wondered if you've seen anything for the D-series
https://www.jhpusa.c...0&idcategory=98
In theory, we should be able to fabricate this ourselves if we needed to. This would basically remove the need to move our hood latch ever single time we need to fill the coolant. Thoughts?
Edit: Found an example of someone doing this for the D-Series:
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing