I Like Dry Toast

I will take one pair.

Thank you for that information.  I went to the parts books and they have the spacer included in the parts drawing, but no mention of it in the listing below the drawing.

 

I'll have to make one.

 

Thanks again.

I'll be using a 15/16" MC. The Civic sedans of this era are getting scarce in these parts. I can make a spacer if necessary. How thick is the spacer? When you say two different lengths are you talking about the pedal clevis?

Why look for a solution in the suspension?

If you apply an aero aid at one end and it upsets the balance, then apply an aero aid at the other end to reset the balance.

A splitter, a lower air dam, cannards, etc.

Thanks for responding.

 

I thought of including the Integra parts but they have different P/Ns for the Hub/Bearing.

 

The dimensions from the parts books seem the same in most respects with the one difference being the width of the bearings.

 

Offsets, and flange diameters, are the same.  The bearing ID is called out as 1.124" on the Integra and 1.12" on the Civic.  Is it really .004" different?  I doubt it.  The parts books just have to get these numbers pretty close for most purposes.

 

Will this spindle give the car a wider or narrower track?  I don't know.  Do you?  Has anyone done this particular swap?

 

What the heck.  I'll give it a try.  Let's do this.

 

Tried to PM you.  It says you can't receive anymore messages.  Full inbox?

 

Thanks,

Tom

 

BTW, I listed the size in the original post as 1.21".  That was wrong.  The dimension is really 1.12".  Sorry if that confused anyone.