29 replies to this topic

[breadvan]

here some pics i took with my camera phone (kinda crappy pics).this is what ive been working on for the past two months.after sleepless nights and lots of sweat and hard work. its a b20a5 from an 89 prelude si. all the mounts were fabricated as were the headers and some wiring.the shift linkage is normally through linkage, while now operated throgh cable. as far as this swap compares to the old setup (slightly modded d16a1) its a helluva lot quicker with improved tq. it just has the basics for now:

ghetto fabbed header
diy cold air intake
2 1/4 exhaust dumped into a dynomax super turbo
ported & polished head/intake manifold/tb
msd 6a
msd coil
ngk wires
b&m fpr
arp rod bolts
lightened crank pulley
act clutch
99 crv yellow powdercoated valve cover
89 integra fuel pump
87 d16a1 integra ecu/harness/dizzy/cam sensor/axles/spindles/brakes
tokico 5 ways w/ground control coilovers
gutted (weighed in at 1720 lbs with previous d16a1 setup)

plans call for new paint,cam gears,ctr pistons and upgrade to obd1 for tunability, as soon as the wallet allows for it (its hurtin right now).well, on to the pics.








well there you go : throws on flame suit:

Edited by breadvan, 07 May 2006 - 09:31 AM.

[JeepGirl]

oh my freakin gawd!!!!


how much BFH work did you have to do before it would go in?

[breadvan]

oh my freakin gawd!!!!


how much BFH work did you have to do before it would go in?

<{POST_SNAPBACK}>

lots, but thank gawd it finally happened

[Disco Stu]

Nice work! Wish mine looked that clean!

[DEIVIONCRX]

that looks realy good, thoes motors are kinda spiffy, i just wish they had more in common with the other B20 or B-series

[breadvan]

that looks realy good, thoes motors are kinda spiffy, i just wish they had more in common with the other B20 or B-series

<{POST_SNAPBACK}>

well, i can at least add other b series pistons. the stock bore is 80 mm. i may get some ctr slugs or stock b16 ones,time will tell.

[JDC420]

That is amazingly amazing. I see the B20a5 in the yards all the time, they make me drool sometimes.

[breadvan]

thanks for the replies

[badpenny]

nice. Very nice.

[bigk3000]

what are the specs on that motor hp and tourqe wise?

[crazi-85crx]

major props. i'm glad to see the msd is going to good use .

[breadvan]

what are the specs on that motor hp and tourqe wise?

<{POST_SNAPBACK}>

obviously more than a blacktop d16

[chedda_j]

ACtually not really.

B20A5 2.0 16V DOHC PGM-FI 1955 110hp@5500rpm 114tq@4500rpm 87-91 Prelude 2.0 Si

[breadvan]

ACtually not really.

B20A5  2.0 16V DOHC PGM-FI          1955 110hp@5500rpm  114tq@4500rpm  87-91  Prelude 2.0 Si

<{POST_SNAPBACK}>

sorry 135 hp/111 tq.

[chedda_j]

Sorry that i quoted info from another site *rolls eyes*