I am rebuilding the old carb and would like to replace my float needle and the o-ring under the float level adjustment screw.
Question: How do I remove the float needle and get at that o-ring?
Can I twist it out from the top adjustment screw? This seems to stop after just a few turns and I don't want to break anything...
Other option, from the bottom, but I would have to remove the float, I am stuck here as well! The small axle that that the float is attached to the carb by doesn't want to budge.
Which way does it come out? I see one end of the axle that is sticking out and the other is flush, I'm not even sure which end to apply pressure.
Has anyone replaced their float and pin and o-ring etc.?
Thanks Guys!
Edited by L4ugh1ngM4n, 27 February 2013 - 02:32 AM.