QUOTE (DEIVIONCRX @ Jun 21 2008, 11:38 AM) <{POST_SNAPBACK}>
Did you add the wires for the crank angle sensor? Did you use shielded wire?
Check and make sure the B16 Map sensors wire placments are the same as the EW4 one. It could be the wires are reversed so when you plug it in, it doesnt work correctly.
Check and make sure the B16 Map sensors wire placments are the same as the EW4 one. It could be the wires are reversed so when you plug it in, it doesnt work correctly.
yeah i did wire the crank angle sensor. i used the stock EW4 engine harness on the B16 and used the wires that were in the Harness for it and ran the Ignition signal wire and the oher two wires along side the fire wall to the distributer.
to get things a lil better i used the stock EW4 MAP ( wrigged up) for right now and it runns better but not good so yeah i think my wires are connnected wrong so i gotta mess with that . but runs fine with the EW MAP sensor.