Jump to content




D16 And Zc

Started by tyrone, Oct 23 2004 05:11 AM

  • You cannot reply to this topic
6 replies to this topic

#1
tyrone
Posted 23 October 2004 - 05:11 AM

is the flange for the d16 and the ZC the same on the head. also is the height of the block the same.

#2
cbstdscott
Posted 23 October 2004 - 09:17 AM

  • Swap in HF drums, check your cam timing
  • PipPipPipPipPipPip
    • Group: 2015 Contributor
    • Location:CRX Heaven, Los Angeles
    • Drives: '87 CRX Si, '07 Civic Si Sedan, '15 Scion FRS
    • Image Gallery
If you are asking about using a D16 header on a ZC, yes it will work.

Scott
Posted Image

Form Follows Function

#3
tyrone
Posted 23 October 2004 - 05:18 PM

yeh i was thinking of getting a bisimoto header but they asked me to find out the info as they didnt make one for my car

#4
tyrone
Posted 24 October 2004 - 06:05 AM

does anyone know the height of the block please

#5
4dr
Posted 24 October 2004 - 10:52 AM

  • SOHC Honda Cowboy!
  • PipPip
    • Group: Members
    • Location:Northern California
    • Drives: 1989 crx Si, 1994 civic Dixxer 4dr, 1986 dixxer CRX(RIP)
    • Image Gallery
QUOTE
is the flange for the d16 and the ZC


if you mean the DOHC D series "ZC" then per greddy's old header which is no longer available for the DOHC D series then, if i remeber correctly it works with very slight modification to one of the outer bolt holes needing dragged over. a dremel would likely work.

the bisimoto header will work on a DOHC D head because i have seen them installed on my site from members.

NICE header choice btw.

Edited by 4drhseriesEGII, 24 October 2004 - 10:53 AM.

#6
tyrone
Posted 24 October 2004 - 11:05 AM

QUOTE (4drhseriesEGII @ Oct 24 2004, 10:52 AM)
QUOTE
is the flange for the d16 and the ZC


if you mean the DOHC D series "ZC" then per greddy's old header which is no longer available for the DOHC D series then, if i remeber correctly it works with very slight modification to one of the outer bolt holes needing dragged over. a dremel would likely work.

the bisimoto header will work on a DOHC D head because i have seen them installed on my site from members.

NICE header choice btw.

yeh but does the bisimoto header clear the sump

#7
UK-ZC1
Posted 25 October 2004 - 05:35 PM

  • Granny
  • Pip
    • Group: Members
    • Location:glasgow, scotland
    • Drives: '87 EDM ZC1, '02 EDM JAZZ SE SPORT
be carefull on this one, if the header is for a us civic then it may not fit- due to the zc we got in uk cars being tilted back. ie, it will hit the sump. but it can be modded if you know a good welder .

here

Edited by UK-ZC1, 25 October 2004 - 05:36 PM.

Back to 1G CRX


  1. Red Pepper Racing
  2. → 1G Honda CRX/3G Honda Civic
  3. → Technical
  4. → 1G CRX
  5. Board rules