Ignition Timing?
- Red Pepper Racing
- → Viewing Profile: Posts: crxracer87si
Community Stats
- Group 2018 Contributor
- Active Posts 28
- Profile Views 8569
- Member Title Slowpoke
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Male
Previous Fields
-
Drives
element , f550, 86 crx
User Tools
Friends
crxracer87si hasn't added any friends yet.
Latest Visitors
Posts I've Made
In Topic: Throttle Position Sensor Solution For 85-87 Crx Or Civic Si
16 September 2018 - 06:22 AM
In Topic: Jrsc D16A1 In 1G Crx?
16 September 2018 - 06:16 AM
turns out those cardone calipers are wrong p/n. they bolt on fine and look right until you try to put 90 Si pads in them. Ordered what I hope is correct p/n
In Topic: Jrsc D16A1 In 1G Crx?
11 September 2018 - 09:55 PM
Big brake parts showed up today. also scored ebc yellow stuff pads for 24.00 shipped and a brand new ac delco master cylinder for 17 I opened the box to be surprised by a MADE IN JAPAN label sweetness just like oem.
In Topic: Ew1 Head Gasket
11 September 2018 - 09:46 PM
I find it very difficult to believe a fel pro is better than an oem gasket. Maybe they are for honda, I don't use them anymore. I have replaced too many felpro head gaskets in other makes with victor riez ( now mahle) or oem when available. an example would be 5.9 cummins the felpro fire ring is HALF! the width of an oem or mahle. another bit of info mahle is an oem supplier for most manufacturers pistons, rings, gaskets etc. they must be doing something right.
but as far as the original posters complaint I think I saw autozone rents a straight edge. use that and a .002" feeler gage straight across the long way in 3 spots and in a X the feeler gage should NOT fit under straight edge anywhere. you engine machine shop may loan you one or you can buy one off of amazon. https://www.amazon.c...-11&ref=sr_1_11
- Red Pepper Racing
- → Viewing Profile: Posts: crxracer87si
- Board rules
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing