Hi Everyone. I've done a Kakabox style short shifter yesterday and want to show some pic.
And everyone post a pic of your Gear knob aswell
- Red Pepper Racing
- → Viewing Profile: Topics: douglastang
Community Stats
- Group Members
- Active Posts 41
- Profile Views 1571
- Member Title Slowpoke
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Male
Previous Fields
-
Drives
1985 Civic
0
Neutral
User Tools
Latest Visitors
Topics I've Started
Short Shifter And Razo Gear Knob
16 September 2007 - 02:29 AM
Check Out My 8000k Hid
11 September 2007 - 06:25 AM
hi ~ just want to show off my HID on my 85 civic
It's a 8000K H4 Hi/Low made in china, and it's nice and cheap, only Au$180.
Video
It's a 8000K H4 Hi/Low made in china, and it's nice and cheap, only Au$180.
Video
Clutch Cable
22 June 2007 - 03:15 AM
Anyone know this clutch cable will fit a 85 DX 1.5L ??
Diy: Alterator Rebuild
31 May 2007 - 09:00 AM
Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor redpepperracing take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: To get a stronger and stable voltage
Required: Regulator and Brush Assembly
Tools: 8mm, 10mm, 14mm socket
10mm, 12mm, 14mm spanner
Philip head screw driver
Steps:
1. Disconnect the ground cable from battery negative(-) post.
2. Disconnect the wires from the alternator as shown
3. Remove the alternator belt adjusting bolt and remove the alternator nut
4. Remove the alternator belt and remove the alternator
5. Remove the rear end cover us 8mm socket
6. Remove the regulator and brush
7. Use air gun to clean off the dust from the alternator
8. Compare of new and old regulator and brush
9. Install in reverse order of remove
10. Adjust alternator belt tension after installing
11. Voltage before with all the electronic on
Aim: To get a stronger and stable voltage
Required: Regulator and Brush Assembly
Tools: 8mm, 10mm, 14mm socket
10mm, 12mm, 14mm spanner
Philip head screw driver
Steps:
1. Disconnect the ground cable from battery negative(-) post.
2. Disconnect the wires from the alternator as shown
3. Remove the alternator belt adjusting bolt and remove the alternator nut
4. Remove the alternator belt and remove the alternator
5. Remove the rear end cover us 8mm socket
6. Remove the regulator and brush
7. Use air gun to clean off the dust from the alternator
8. Compare of new and old regulator and brush
9. Install in reverse order of remove
10. Adjust alternator belt tension after installing
11. Voltage before with all the electronic on
Integra Shift Linkage
11 April 2007 - 09:54 PM
anyone can confirm 86-89 Integra shift linkage are directly bolt on 85 DX ??
Thx
Thx
- Red Pepper Racing
- → Viewing Profile: Topics: douglastang
- Board rules
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing