Red Pepper Racing

Look at the trailing arm, one end of the axle has a hole n the side at a 90 degree angle, this has been cross drilled, so you can put the needle in to grease the bearing. You can also slide the needle into the bearing and grease it all up that way, which will work on all of the bearings if the grease nipples ever fail.

Would have never noticed if you did not tell me that is the grease port.

Going to attempt to install them this week.
I see in the pictures you have 1 retaining bolt on the torsion bar, or is there more hidden?

Just one, but your more than welcome to use more bolts. I was just going with the same design as David's only using one bolt.

Sent the rest of the $$$$ :0)

Thanks bro, I'm working on your stuff this week, should have it shipped pretty soon.