20 replies to this topic

[84b18]

very nice build..
 
only missing a lip at the rear bumper

I will be making a rear diffuser that will fill out the back nicely. That's one of the next projects.

I want to do something similar to this one but the low spots will be in the center to pass under the exhaust.

Edited by 84b18, 01 March 2014 - 11:13 PM.

[niccer]

My offset is +45, you can go as low as +35 depending on the width. My tire size is a 195 50 15. I had 205s and they were fine, I think you could to 215s with I proper wheel size. If you want to do a lower offset see about buying or renting a fender roller.

 

Wow, it's funny how a not-so wide wheel/tire combo look so great on these cars.  I'm certainly not looking for any sort of hellaflushness or to do any fender work, but would like to end up with something like yours.  Thanks for the response.  

[PuddleSkipper]

Just noticed this, Did you use an EF harness? Thought I spotted the EF engine compartment fuse box anyway...............

[84b18]

Yes i used much of an EF harness, Good eye. The B18 came from an EF donor car so I kept the engine harness with the engine when I transplanted it.

[undr8ed]

Dig the AZ vintage plates!

[84b18]

Thanks, Vicki said the veteran plates would look better with the pearl white paint, But how many Hondas do you see with classic vehicle plates. I believe the regulation is 25 years or older.