xips(86CRXSI)

I need help I have a 86 crx si with a 88 D16A1 DOHC and I'm getting ecu codes 3, 4, and 20. I need to know what to do to fix the problem. the car runs but ldles funny and wont rev up past like 3,000. I need help i'm almost done with this project. Thanks.

I got the down pipe that i needed, put it on and fireed up the engine, and the car runs good at ldle but it wont rev up past like 2,000 rpm, my tac is not working along with my turn singnals, hazards and dash lights. the ECU is givin me codes 3,4,14,15,and 20. code 3 is for the MAP sensor, code 4 is for the Crank Angle Sensor, code 14 is for EACV, code 15 is for the Ignition Output Signal, and code 20 is for the ELD. Can anyone tell me what would make the car not rev up? anyone have this problem? or does anyone know what I need to do? I relly need some help. Thanks guys

Ok I hooked up the ELD today and tryed to start the car, it still wont fire up I thought I needed the ELD hooked up to make it start, but I apparently I was wrong. and thares something else going on that shouldent, when you have your key in the Ignition and the car is off, the car makes a noise so you dont lock your keys in the car, and the noise is suppost to stop after you turn the key to the Ign #1 position, well the noise stays on all the time no matter what position the key is in, thats one problem, next my turn signals and hazered lights dont work, thay did before the swap, but not anymore thats problem number two, and number three problem is that it wont start. The car sounds like its about to start and then it doesent. any help would be great. O heres the swap I was trying to copy. go to this web page http://www.muller.ne...wap2/index.html l did this to my wiring and added all the wires except the A/C Clutch Relay, Radiator Fan Relay, and the Brake Switch. and I did the same thing with the coil power wires that he did, and it still wont start, I dont think its getting spark, will you look over this guys swap info and let me know whats wrong or if i'm just handicapped, Thanks Again.

I have the engine in, the crx engine harness modified, know the right wires to hook up, but the crx manual doesnt show the location of the unused pin# at the ecu for exp A-17 shows what color the wire is and whare its going and is a stock wire in my 86 crx si, but I need to know the locatin of PIN#'s A10,A13,A14,B1,B2,B3,B4,B5,B10,B12,B15,B16, . All of these are locations whare I need to add wires. if any one can help that would be grate. I busted my engine in my Blazer and just sold my caprice and need to get my crx running so I can get around. PLEASE HELP