Sign In
Create Account
Let me know if you have one or can get one and price please it's the pipe on the back of the block that goes from the water pump housing to the thermostat housing, need it to finish freshening up the motor and then sell the car. Thanks guys!
0
Water Pump Inlet Pipe
Started by IfTakumiDroveACRX, Oct 08 2007 09:55 AM
8 replies to this topic
#1
Posted 08 October 2007 - 09:55 AM
-
- Can't stop the greatness in motion....just you wait...
-
- Group: Contributing Member
- Location:Baldwin Park, CA
-
Drives: 85 crx Si two-tone black/grey, 72 Datsun 510 with an experimental rotary swap (the engine is a 12a and 13b hybrid), Infiniti G35 sedan on air suspension rolling on 19" G-Corp's Estatus wheels and various Garson/D.A.D accessories
-
Image Gallery
Back to top
#2
Posted 08 October 2007 - 10:39 AM
-
- 1985 Mugen CR-X Si
-
- Group: Contributing Mod
- Location:Cincinnati, OH USA
-
Drives: 1985 CRX Si, 2006 Ford Focus ST, 2009 Lexus RX350, 1996 Del Sol Vtec
-
Image Gallery
you looking for a new or used one?
I may have one I can sell you frrom an 89 integra.
Ill have to check and make sure its still on there...
ill let you know this evening if i have it, and you can make an offer.
I may have one I can sell you frrom an 89 integra.
Ill have to check and make sure its still on there...
ill let you know this evening if i have it, and you can make an offer.
#3
Posted 08 October 2007 - 01:14 PM
-
- Slowpoke
-
- Group: Members
- Location:Hopkinton, MA
-
Drives: CRX, YukonXL, 65 Cobra, Mazda6
If funkmaster doesn't find one, send me a pm and if there's any chance that you can find a drawing/picture, that would be great. I've boxed up the block but might have this thing still hanging around. Not sure and a pic would give me something to dig for.
jack
jack
#4
Posted 08 October 2007 - 01:45 PM
-
- Can't stop the greatness in motion....just you wait...
-
- Group: Contributing Member
- Location:Baldwin Park, CA
-
Drives: 85 crx Si two-tone black/grey, 72 Datsun 510 with an experimental rotary swap (the engine is a 12a and 13b hybrid), Infiniti G35 sedan on air suspension rolling on 19" G-Corp's Estatus wheels and various Garson/D.A.D accessories
-
Image Gallery
here you go guys and thanks let me know!
#5
Posted 12 October 2007 - 12:31 PM
-
- tinker, tinker....BOOOOOOM!!!! then I run around
-
- Group: Contributing Mod
- Location:Hurst, Texas
-
Drives: Don't, because they don't run and I am a crappy mechanic.
-
Image Gallery
View Garage
QUOTE (IfTakumiDroveACRX @ Oct 8 2007, 01:45 PM) <{POST_SNAPBACK}>
here you go guys and thanks let me know!
Why not pull one off a dx, they are (IIRC) the same part number.
Honda, because it's hard to look baller in your mom's Volvo.
The entire tool selection at Sears or the contents of a Snap-On truck will do you no good if you do not know how to use them.
The entire tool selection at Sears or the contents of a Snap-On truck will do you no good if you do not know how to use them.
#6
Posted 15 October 2007 - 08:25 AM
-
- Can't stop the greatness in motion....just you wait...
-
- Group: Contributing Member
- Location:Baldwin Park, CA
-
Drives: 85 crx Si two-tone black/grey, 72 Datsun 510 with an experimental rotary swap (the engine is a 12a and 13b hybrid), Infiniti G35 sedan on air suspension rolling on 19" G-Corp's Estatus wheels and various Garson/D.A.D accessories
-
Image Gallery
QUOTE (Jack ffr1846 @ Oct 8 2007, 01:14 PM) <{POST_SNAPBACK}>
If funkmaster doesn't find one, send me a pm and if there's any chance that you can find a drawing/picture, that would be great. I've boxed up the block but might have this thing still hanging around. Not sure and a pic would give me something to dig for.
jack
jack
thanks everyone....especially Jack! thanks for the part feedback left! thanks again!
#7
Posted 15 October 2007 - 08:33 AM
-
- The Green Snowplow
-
- Group: Contributing Member
- Location:Dearborn, MI
-
Drives: 1986 ITC Civic
I think I have an extra one of these. Non Si. Let me know if you didn't find one elsewhere.
My driving skills fall somewhere between The Stig and Sammy Hawkins!
#8
Posted 15 October 2007 - 11:29 AM
-
- In the left lane
-
- Group: Members
- Location:Chicago
-
Drives: 1987 CRX Si - D16a1
-
Image Gallery
i guess honda doesnt make these anymore?
Recyling is not the answer. Using less to begin with is.
#9
Posted 16 October 2007 - 08:17 AM
-
- Can't stop the greatness in motion....just you wait...
-
- Group: Contributing Member
- Location:Baldwin Park, CA
-
Drives: 85 crx Si two-tone black/grey, 72 Datsun 510 with an experimental rotary swap (the engine is a 12a and 13b hybrid), Infiniti G35 sedan on air suspension rolling on 19" G-Corp's Estatus wheels and various Garson/D.A.D accessories
-
Image Gallery
well Jack sent me one already and I'm ok now so we should be good, if I need anything else i'll let you know guys thanks!
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing