6
My B16a Build
Started by ballade, Nov 04 2010 09:42 PM
243 replies to this topic
#241
Posted 25 August 2011 - 11:25 AM
the clutch was also chattering like mad from day one.
I think their quality control is to blame. some are good others crap.
I will admit it bit hard, but it isn't needed on my setup.
current setup works great.
I think their quality control is to blame. some are good others crap.
I will admit it bit hard, but it isn't needed on my setup.
current setup works great.
#242
Posted 25 August 2011 - 06:28 PM
QUOTE (ballade @ May 14 2011, 08:20 PM) <{POST_SNAPBACK}>
Swapped out the intermediate shaft with a known good one and still no change.
Hasport will be sending out a new PS drive shaft next week.
Hasport will be sending out a new PS drive shaft next week.
Are your axle problems sorted out yet?
If so, What was the ultimate solution?
Jeff
#243
Posted 25 August 2013 - 07:57 PM
From the dead!
So after the B16A install I've had this buzzing from both sides of the car. drove me nuts.
I was sure it was attributed to the Hasport mounts. it occurs around 4000 rpm. and drove me insane for 3 years, until today.
With the road trip only a few weeks away I've started picking away at the car.
The buzzzz was with me on the last trip and it was time to get rid of the little bitch.
it was the door stopper, Pulled the door cover and wraped some tape around the rod.
problem solved. Thank god
#244
Posted 22 September 2013 - 10:14 PM
Every little buzz gets me heated as well man. I've lost the battle at the moment though, too many I've left for too long. lol