QUOTE (rally25rs @ Jul 16 2004, 03:36 PM)
I see it is a ZC trans, but I thought the ZC and USDM trannies wee different...
If it is a direct, no fabrication, made for this tranny bolt-in, then I just may be in!
there may indeed be some modification to install but the only way to know is if we can get some dimensions(or a diff) from cusco on the diff and measure a US model to double check. as best i can tell the us and jdm trannies 86-89 teg were identical except for final drive ratio. i don't doubt that there might be slight mods that have to be done, like removing a rib inside the original si tranny to install the mugen diff in the case.
the 88-91 l3(2g zc) style diff is different than the teg one. and the zc88-91 2g zc diff has the same spline size and diameter as the 86-93 integra
may be MR .D can get us some drawings of the diff. i have a 87 teg tranny in the garage to compare too, and an 88 in the car.