my buddy and i put a new transmission in and i forgot to tighten the alternator pulley bolt.... needless to say it made quite a racket until it finally fell out and i ran the pulley over.... grrr
so its a sunday and i was going to go down to the parts store to see if they had a bolt that would work as a replacement...
anyone know what kind of bolt this is? it holds the alternator pulley to the crankshaft, so its quite large... i remember the head of the bolt being double the size in length of a reg bolt and i think it was 17mm but im not sure...
please help me......
0
Aww crap... anyone know what this bolt is?
Started by Below Ambient, Nov 24 2002 11:53 AM
5 replies to this topic
#1
Posted 24 November 2002 - 11:53 AM
#2
Posted 24 November 2002 - 12:00 PM
#3
Posted 24 November 2002 - 12:12 PM
That is a crank pulley bolt. I doubt that your local pep boys or autozone will hwve one. It is going to probably be a special order from honda. I would chect the wrecking yards.
#4
Posted 24 November 2002 - 12:22 PM
thanks man.... i wanted to know the specs so i just replace it... doesnt have to be factory does it?
#5
Posted 24 November 2002 - 03:01 PM
I think factory would be best. I might have the one off my D16 kicking around, or I could pull the one off my 133 block. If you have problems getting one let me know.
"Toby, you are a thief of joy"