Thanks for responding.
I thought of including the Integra parts but they have different P/Ns for the Hub/Bearing.
The dimensions from the parts books seem the same in most respects with the one difference being the width of the bearings.
Offsets, and flange diameters, are the same. The bearing ID is called out as 1.124" on the Integra and 1.12" on the Civic. Is it really .004" different? I doubt it. The parts books just have to get these numbers pretty close for most purposes.
Will this spindle give the car a wider or narrower track? I don't know. Do you? Has anyone done this particular swap?
What the heck. I'll give it a try. Let's do this.
Tried to PM you. It says you can't receive anymore messages. Full inbox?
Thanks,
Tom
BTW, I listed the size in the original post as 1.21". That was wrong. The dimension is really 1.12". Sorry if that confused anyone.