is the flange for the d16 and the ZC the same on the head. also is the height of the block the same.
0
D16 And Zc
Started by tyrone, Oct 23 2004 05:11 AM
6 replies to this topic
#1
Posted 23 October 2004 - 05:11 AM
#2
Posted 23 October 2004 - 09:17 AM
If you are asking about using a D16 header on a ZC, yes it will work.
Scott
Scott
Form Follows Function
#3
Posted 23 October 2004 - 05:18 PM
yeh i was thinking of getting a bisimoto header but they asked me to find out the info as they didnt make one for my car
#4
Posted 24 October 2004 - 06:05 AM
#5
Posted 24 October 2004 - 10:52 AM
QUOTE
is the flange for the d16 and the ZC
if you mean the DOHC D series "ZC" then per greddy's old header which is no longer available for the DOHC D series then, if i remeber correctly it works with very slight modification to one of the outer bolt holes needing dragged over. a dremel would likely work.
the bisimoto header will work on a DOHC D head because i have seen them installed on my site from members.
NICE header choice btw.
Edited by 4drhseriesEGII, 24 October 2004 - 10:53 AM.
#6
Posted 24 October 2004 - 11:05 AM
QUOTE (4drhseriesEGII @ Oct 24 2004, 10:52 AM)
QUOTE
is the flange for the d16 and the ZC
if you mean the DOHC D series "ZC" then per greddy's old header which is no longer available for the DOHC D series then, if i remeber correctly it works with very slight modification to one of the outer bolt holes needing dragged over. a dremel would likely work.
the bisimoto header will work on a DOHC D head because i have seen them installed on my site from members.
NICE header choice btw.
yeh but does the bisimoto header clear the sump