21 replies to this topic

[toxicshit]

Hello every one,

today i sandblasted the intake and all the valves and sensors on the intake inlcuding the throttle body and fuel rail. and i thought i could post some pictures of my Swapping saga over here.











I used an sand blasting air tool i a home made sandblasting cabinet with sand make of crushed sea shelves. and before i began with blasing i de greased it all with oven cleaner..

The intake is from a B16a1 engine wich i going to replace my current ZC1-AS53 engine .

Greetings Erwin.

[bombayscrx]

nice , good job

[toxicshit]

thnx i was a hell of a job. tomorrow ill start on the head and the day after i will blast the engine it self.. ill keep you guys updated

[Aren D.]

that looks really good!

[toxicshit]

yes it looked better than i hoped i would look its like brand new

[C8V6C]

Not bad....lost its bling though

[yungdriva]

what exactly is sand blasting?

[bombayscrx]

sand-blasting....blasting something with sand

[toxicshit]

yes like bombay told you blasting a part clean with sand.

some new pictures of today :







those cylinders look good





Now im going to put it all into the dish washer to get it nicely grease free and clean

Greetigns Erwin

[C8V6C]

mmmm....what is that? headgasket blow?

[toxicshit]

yes the headgasket was blown and the stuff you see in the bottom of the clylinders is som black burn residu thats always in your engine..

i dont know the english wordt for it only the dutch.

[toxicshit]

Some proof for the people that say that a B18c6 (ITR ) exhause header sits lower than a B16 exhaust header, as you can see thats total bullshit.. the oil pan sits lower than the B18c6 ITR header. and i measured it on my other B16a2 engine with A2 header.. and both the headers have the same ground clearance !

[CSPCRX]

I believe what most people refer to is the 4-2-1 vs the 4-1. The B18C5 JDM ITR with the 2.5in collector and the 4-1 design does sit lower because you have the 4 pipe coming together under the pan. The 4-2-1 B16A, B16A2, B16B, B18C (5) 4-2-1 all sit about the same distance. I have been told, cant confirm, that some B16 headers will not fit on the B18C (5) because of the difference in deck hight. This would cause some B18C (5) to sit lower on the B16 motor.

[toxicshit]

yes it had to do with the deck hight of the B18C6 ITR engine and a normal B16A1 CRX engine i took both headers and they are same lenght so no ground clearence problems

BTW i test fitted the B18 header for my girl friend she has an Delsol Vtec and wants the B18 Intake and exhaust header on it because of some good dyno results we have seen with that setup on a B16 engine.

Greetings

[toxicshit]

today i got a nice present from a good friend of mine he made me a verry clean valve cover to match with my engine.








What do you guys think of it ?

Groet Erwin