Yes. You will have the pizza linkage that came with your carb. It's the one with like 6 holes in it in the picture. Then a spacer that is not as tall, and finally a linkage piece that is similar to the pizza linkage. The cable will lay on the spacer and the cable end will sandwich between the pizza linkage and the new piece.
Make sure the spacer is thick enough so that the cable does not bind between the pizza and new linkage when you tighten them together.
I removed the pizza linkage to match the three holes that I drilled in the new linkage piece and the two holes that I drilled in the spacer. Two bolts go through the bottom two holes in the pizza, spacer, and new linkage piece to hold it all together. One hole is drilled in the new linkage piece so the cable end can sandwich between the pizza linkage and new linkage.
Ensuring the cable end is secure is imperative. So you want a spacer that is thick enough so that the cable doesn't bind and also thin enough to allow the cable end to snugly fit in the holes between the pizza linkage and the new linkage piece. I think I used 1/8th inch thick aluminum but can't remember exactly.
Again, I will try to take better pictures this weekend.
See my crappy picture below. (Sorry. I'm at work and made this in paint over the course of 2 and a half minutes.)