Not that I'll convince you but you would be surprised what that stuff does.
isn't no snake oil. I had three gears which were toast. I ended up selling the tranny but kept the fluid LOL no joke!
id rather just get the transmission from Mrfixit, hold on to it as a spare or rebuild it like new if i get around to building a side draft engine, this transmission had the magnets completely layered and covered with metal.. i ripped it apart for fun cause its just sitting around, and i figure i can use some parts out of it if need be
As for JEA86's Problem.. he has oil leaking Into the transmission housing from the mainshaft, im guessing theres a seal behind the bearing??
EDIT:
JEA86 You are correct, there is a oil seal for the main shaft under the bearing, i hope i dont have to pull my transmission again... i have 0 tolerance for oil leaks, to change this seal your gonna have to remove the main shaft, pull the bearing, change the seal, then put all new bearings in, and inspect your transmission (Might as well check everything out since its open) youll hate urself later if a bearing goes out and u need to pull it again so u might as well do it while its out..
013 91216-PA0-003 OIL SEAL (22X35X7) (ARAI)