Like it says, I'm using a pretty nice CRX for a parts car. The interior is not needed, the car is for club race spare parts so everything other than running gear can go. Anyone needing dash, etc. should let me know before it hits the dumpster.
You can contact me at [email protected]
James
2
Parting Out An 86 Crx
Started by jwr914, Jul 22 2009 12:02 AM
6 replies to this topic
#1
Posted 22 July 2009 - 12:02 AM
#2
Posted 22 July 2009 - 02:35 AM
#3
Posted 22 July 2009 - 04:08 AM
#4
Posted 22 July 2009 - 05:45 AM
houston
Honda, because it's hard to look baller in your mom's Volvo.
The entire tool selection at Sears or the contents of a Snap-On truck will do you no good if you do not know how to use them.
The entire tool selection at Sears or the contents of a Snap-On truck will do you no good if you do not know how to use them.
#5
Posted 11 September 2009 - 09:13 AM
You'd be assuming wrong. It's an Si. I bought it simply for the intake manifold. I'll probably only keep the front hubs and a few other bits.
I also have a bolt in AutoPower roll bar system for a 84-87 Civic that I need to get out of the garage. Two ew motors and transmissions. I was going to make this car a NASA car for my son, but bought a Subaru STi already built car instead. (It's cheaper than building a new Honda) ;-)
I also have a bolt in AutoPower roll bar system for a 84-87 Civic that I need to get out of the garage. Two ew motors and transmissions. I was going to make this car a NASA car for my son, but bought a Subaru STi already built car instead. (It's cheaper than building a new Honda) ;-)
QUOTE (Lymitliss @ Jul 22 2009, 04:08 AM) <{POST_SNAPBACK}>
I'm assuming it's not an Si...
James Rogerson
84-87 Civic SCCA HP
2006 S2k daily driver
#6
Posted 12 September 2009 - 10:10 PM
All the engine stuff is gone except for a JDM carb I forgot to give to Zak and if he wants it he knows where it is. I didn't get pictures for the Si molding and it'll have to wait until after the SCCA runoffs. I fly out tomorrow and will not be back for two weeks.
QUOTE (jwr914 @ Sep 11 2009, 09:13 AM) <{POST_SNAPBACK}>
You'd be assuming wrong. It's an Si. I bought it simply for the intake manifold. I'll probably only keep the front hubs and a few other bits.
I also have a bolt in AutoPower roll bar system for a 84-87 Civic that I need to get out of the garage. Two ew motors and transmissions. I was going to make this car a NASA car for my son, but bought a Subaru STi already built car instead. (It's cheaper than building a new Honda) ;-)
I also have a bolt in AutoPower roll bar system for a 84-87 Civic that I need to get out of the garage. Two ew motors and transmissions. I was going to make this car a NASA car for my son, but bought a Subaru STi already built car instead. (It's cheaper than building a new Honda) ;-)
James Rogerson
84-87 Civic SCCA HP
2006 S2k daily driver