I bought a set from the first batch and only had a few small problems:
1. The main bolts were a little too short. They still worked but Tom quickly sent me longer bolts to make sure there were enough threads on in the nut. I assume the next batch won't have this problem.
2. A plastic cover on the firewall had to be removed along with the bracket on the shock tower. As you can see in this picture this camber plate is raised to clear it. I just need to grind down the bracket to make fit it again or just drill a new hole.
(not my car, not the rpr camber plate, just used for reference about the cover and bracket)
![](https://www.redpepperracing.com/gallery/albums/cplates-proto/abc.sized.jpg)
3. I'm getting a small rattling between the bearing and machined aluminum sleeve, about 1mm of play. I believe a simple washer will fix this problem but my car is in the shop right now so I can't work on it yet.
Other than those small issue the camber plates are very nice. I was also pleasantly surprised when I noticed that the holes for the main bolts were threaded, it would have been easier to just make them regular holes but Tom didn't take any short cuts there.
Sorry I don't have any pictures of the installed camber plates but I'll try to have some up tomorrow.