Mackwagon's Content

#533268 D16a1 Trap Door Baffled Oil Pan

Posted by Mackwagon on 07 January 2012 - 09:40 PM in FS

We built a hinged door baffled oil pan for our hondAcura lemons race car. That car is headed to the crusher. But i pulled the oil pan off. Somebody doing autocross or road course racing with a D16A1 will want this as extra insurance against oil starvation. This is a Junk Yard pan so it has a welded up hole in the bottom, so it doesn't look perfect. The interior of the pan was stripped and cleaned and then the baffle and hinge plates welded in. its home built, but it works, we used this in 3 races with the same engine and it worked just fine. Comes with a perfect used pan gasket. I can send a picture of the interior. its been cleaned of oil. best offer plus shipping from Hayward, CA

#532887 Wtb. 1st Gen Integra Parts

Posted by Mackwagon on 30 December 2011 - 01:33 PM in WTB

QUOTE (fritt @ Dec 29 2011, 10:14 PM) <{POST_SNAPBACK}>

I need 86-89 integra
- Manual transmission
- Half shaft
- Flywheel
- Front knuckles
- Driver + Passenger axles
- Shift linkage
- Motor and trans mounts

Anyone in the 604 area just send me a message if you got these parts.

In Hayward, CA, I have for sure, the flywheel and a clutch ,and shifter linkage that I could ship out to you. By front Knuckles you mean the front spindles? or Front hub carriers. So the hub carrier, the front bearing, the front hub, and maybe the front brake rotor?? I have a set of those. I should also have the full motor and transmission mounts and the half shaft. No axles (just buy rebuilt or new ones from Autozone, it will be cheaper than buying used ones and paying for shipping.

I am selling off a honda civic race car (24 hours of lemons) either as a whole car or parting it out (on the 24 HoL forum). If I part it out, I will have the manual transmission and maybe the drive axles for sale.

#529374 Need Some Integra Parts For A Swap

Posted by Mackwagon on 17 October 2011 - 01:46 PM in WTB

I sent you a message directly, but I'll repost here also. I have the:

5spd 89 Integra complete shift linkage
5spd 89 Integra front tranny mount
5spd 89 intermediate shaft (you can buy new complete axles from a auto parts store)

89 Integra engine harness but I have to check on its condition

I can ship them from Hayward, CA to Bakersfield, CA

#527634 Need A Few Things

Posted by Mackwagon on 12 September 2011 - 01:31 PM in WTB

QUOTE (jsgprod @ Sep 12 2011, 09:36 AM) <{POST_SNAPBACK}>

I also need a passenger side, inner CV joint housing from a D16 Integra. Just the housing and it needs to be the passenger side, according to Kirk they are slightly different.

Thanks,
Jay

Jay,

I have an 89 Integra that I'm parting out (engine donor for a 1984 civic hatchback 24 Hours of Lemons car). I think I have the CV housing you need on one of our transmissions. Basically this is the inboard end of the CV joint, which usually is part of the passenger drive shaft(?). I'll take a picture tonight and get that sent to you.

Dan H.

#525819 89 Integra Part Out Last Call

Posted by Mackwagon on 08 August 2011 - 09:49 PM in WTB

I have a 89 Integra that i have been parting out. There are still some good parts available before I cart this thing off to the recycler. The car is located in Hayward, CA

Already SOLD or gone:
Engine and Transmission-these went into the Lemons car. but they will be available after October 23rd.
interior panels
Windshield
rear brakes
front lower lip
Front control arms, maybe the front cross-member.

STILL have:
The whole car minus the sold stuff.
The front hub assemblies with Brakes!
the ECU
The seat belts which are in really good condition, this car spent its life in foggy San Francisco
the tail lights, and front lights and the metal panel between the taillights
carpeting
Seats (out of the car already).
Dash (good condition, no cracks!)
Wheels with new tires (about 2/5s worn from racing in the rain in May).

I'll be on line, but out of town August 14-18, but otherwise I can take photos and get you information.
Thanks Dan

#525340 86-89 Integra Passenger Side Front Lower Control Arm

Posted by Mackwagon on 30 July 2011 - 02:14 PM in WTB

I have the fronts from an 89 I'm parting out. Sent you a message

#518448 1989 Acura Integra Part Out

Posted by Mackwagon on 07 April 2011 - 05:37 PM in FS

UPDATE: I'm a newbee Red Pepper guy so I can only answer messages once every 2 hours. So send me a message and include your e-mail address.

I have an 1989 Silver Acura Integra that I'm parting out before towing off to the JY or steel recycling. Right now (4/7/2011) it has everything except for the engine and transmission. The interior is gray/blue and in really great condition. The dash board is near perfect. Seats are good. The body is in good condition except for the left front fender and drivers door sheet metal. new alternator, I think the drive shafts are nearly new, Radiator is pretty new. Rear hatch struts are NFG. Battery brand new (probably can't ship that).

14 in stock Aluminum wheels with some 195/60 tires that saw one 9 hour rainy day at Sear Pointless (24 hours of lemons) on a honda civic.

The car is located in Hayward, Ca and I can ship parts out.

I do have some extra engine internals/externals that I can sell of, but its better if you ask for what you want and I'll get back to you ASAP.

http://sfbay.craigsl...2314097452.html

Dan

#518447 Wtb Integra Torsion Bars And Tubes

Posted by Mackwagon on 07 April 2011 - 05:26 PM in WTB

D,

I have a 89 integra that I'm parting out. I can get you these. I'm in California. How much money do you have???

Dan

#518314 Wtb Teg Lower Shift Linkage

Posted by Mackwagon on 06 April 2011 - 09:39 AM in WTB

Garrett,

did you find a shifter linkage?? I have an 89 integra that I'm parting out, Hayward CA. I could ship it to you.

Dan