The felpro gasket only works with stock bore. You need the d16a1, as mentioned above, to fit overbore. Best to check the head and block with a machinists straight edge. Some other brands will work with overbore , but are hard to clean, and have a shorter life, Dave
- Red Pepper Racing
- → rallyxcrx's Content
rallyxcrx's Content
There have been 5 items by rallyxcrx (Search limited from 10-June 23)
#578924 I Broke The Car Again!
Posted by rallyxcrx on 09 February 2018 - 10:05 AM in 1G CRX
My rear mount has failed more than once. High RPM causes the two top bolts to fall out, and this breaks the tranny case, and when the mount is finished the throttle sticks wide open and the tranny shifter also fails. Now I safety wire the two top bolts together. The bolts are easy enough to drill, and loctite dosen't work. I have a blown motor to fix right now, and yeah, this car kicks ass in the turns, but gets it's ass kick on the straights, Dave
#578749 I'm Slow!
Posted by rallyxcrx on 16 November 2017 - 01:09 PM in 1G CRX
Old tires are about 2 seconds slower than new ones, and if you don't keep your driving sharp, about one second there. Then theres about 1000 things that will make you go faster, suspension, alignment , engine, reduce weight, areo, etc. Nobody said car racing was cheap, I knocked out my automatic transmission in my stock 05 camry last weekend running 2 rallyxs and one autocross. A first and a third rallyxing, and emberrested most of the drivers at the autox, but about a 3500.00 set back, Dave
- Red Pepper Racing
- → rallyxcrx's Content
- Board rules
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing