12 replies to this topic

[oblivionnewtonjohn]

Stock seats in good condition with this pattern: 

 

 

 

Also need the defrost vents in the top of the door panel, no cracks, near mint.

Top dash piece that has the two long defrost vents and the VIN plate, near mint. 

 

 

And I need the drivers side body molding strip that fits where the arrows indicate:

 

Edited by oblivionnewtonjohn, 19 July 2014 - 01:00 PM.

[oblivionnewtonjohn]

Sourced the body stuff from Heeltoe, need the above. 

[E-Man]

If I knew you were going to go through all this I would have reached out to you on my white 86 Si

[MichaelStar]

I might have a passenger seat

[oblivionnewtonjohn]

PM sent
Sent from Nok Nok

[kess]

If you have the seats I have the correct seat covers.

[oblivionnewtonjohn]

PM sent. 

[oblivionnewtonjohn]

What a waste, just talked with AAA Auto Recyclers in Dallas that listed both on Car-part.com, went to the crusher, seats and all. Wow 

[NWClassicHonda]

I have the door caps. 206-940-8173

[oblivionnewtonjohn]

I need the molding, did you find them?
Sent from Nok Nok

[oblivionnewtonjohn]

Still looking for all of the above. Just so I am clear, I am only looking for the door strip molding that fits on cap, not the cap itself. 

 

Spence 

[strudel]

Still looking for all of the above. Just so I am clear, I am only looking for the door strip molding that fits on cap, not the cap itself. 

 

Spence 

Still not sure what you need. The cap pictured below or the clips that hold it on or the actual plastic side door panel? I have these for sale. JS

[oblivionnewtonjohn]

Appears to be it. Molding assembly Part # 75805-SB2-003 http://www.hondaauto...gry5=DOOR PANEL

 

 

PM sent