komet 163

help ... someone has a diagram of the wires of the lights and turn signals ... I did a swap and some wires are disconnected, and the lights do not work properly

 

 

when I turn the lights red indicators light up, but with low voltage. and green hazards indicators also light up..That should not happen....and when I turn on the hazard indicators flashing good but also flashing brake lights with low voltage

Help, anyone can tell me what position are connected each of these three white wires???

 

Hello crx owners.....I have a 85 CRX Si, which came with a EW3 MPFI engine OBD-0- and I'm changing the engine for D15B VTEC OBD2a. I have all the engine harness OBD2a with the ecu. and I have the whole interior harness OBD-0

 

I want to match the engine harness OBD2a with interior harness OBD-0 .... and so have completely operating the cluster, and the other things to the engine to run properly

 

someone who knows how to do it...thanks

Hi, I'm looking for a wiring diagram for my crx 85. I have the service manual but not any diagram appears.... If anyone can help me...
Thanks

Something like this

Hello,

 

have a problem, my engine starts at very high rpm and stays stuck, and smell gasoline. is a EW3 OBD-0, but when I buy it, I noticed that came with injectors OBD-2 if I'm not mistaken, I read something about the resistors box. when the injectors are changed, but I'm not sure if that will be the problem of high rpm

 

this is the resistor box ???

 

OBD-2 clips ???