Jump to content




Cg Tranny Pressure Plate Torque Specs?

Started by 209CRX, Oct 09 2012 10:23 PM

  • You cannot reply to this topic
2 replies to this topic

#1
209CRX
Posted 09 October 2012 - 10:23 PM

  • Slowpoke
  • PipPip
    • Group: Members
    • Location:Charleston SC
    • Drives: 2013 Honda CBR500RA, 1999 Mazda MX-5 Miata, 1986 Honda Civic CRX Si
    Garage View Garage
Does anyone know the torque specs for the pressure plate on a CG tranny? Is it the same as the stock CRX Si? And... what would happen if you were to under-torque the pressure plate?
Paco

#2
fat_85_civic
Posted 10 October 2012 - 01:22 AM

  • In the left lane
  • PipPipPip
    • Group: 2012 Contributor
    • Location:Wollongong, Australia
    • Drives: 85 Civic 1500S - ZC converted
    • Image Gallery
    Garage View Garage
Straight from the service manual:

26N.m (19lb-ft)

When tightening them tighten them in a criss-cross pattern two turns at a time.

#3
209CRX
Posted 16 October 2012 - 11:10 PM

  • Slowpoke
  • PipPip
    • Group: Members
    • Location:Charleston SC
    • Drives: 2013 Honda CBR500RA, 1999 Mazda MX-5 Miata, 1986 Honda Civic CRX Si
    Garage View Garage
Nice, thanks man.
Paco
Back to Transmission


  1. Red Pepper Racing
  2. → 1G Honda CRX/3G Honda Civic
  3. → Technical
  4. → Transmission
  5. Board rules