Oh yeah, aluminum rear drums.
It is good to be back.
Scott
The aluminum drums are lighter than the iron drums. The iron drums are lighter than the rear discs. Many years ago somebody tried to prove me wrong and install discs that were lighter than the aluminum drums. He ended up with go-kart brakes. Look it up on this site.
Good question. It would require someone with nothing better to do and all the right bits to get the exact numbers.
You don’t need to change the backing plates. I didn’t when I switched mine.
Victor
86 K24 Powered CRX SI (SMF Solo2, HPDE-4 NASA & TA-A Time Attack
85 CRX DX totally original
07 Harley FXST Softail
2021 Tacoma Tow/Daily
You have to include the weight of the caliper and the bracket to hold it for the rear discs. Let's assume at least one pound (but realistically it would be maybe closer to three pounds or more), it become apparent that the aluminum drums are the lightest choice.
For a car that has 60% of its weight over the front wheels at rest and far less under braking, you can see why the aluminum drums works so well.
You don’t need to change the backing plates. I didn’t when I switched mine.
In my experience, some backing plates don't "rub" on the aluminum drums, some do. Backing plates for cast iron drums have an inner "lip" that can be very thin (that bends and rusts) or they can be thick. The thick lip wouldn't allow the aluminum drum to turn, on one of my CRXs. The thin lip needed just a little straightening with needle nose pliers. And just a couple of miles of rubbing wore any remaining bends.
Keith A. Edwards
Suffolk, VA
1.75 1st gen. CRXs
former ECHC H5 Champion
The 1988 and later Civic backing plates will accept the aluminum drums. That is what I am using on my '87 Si.
In my experience, some backing plates don't "rub" on the aluminum drums, some do. Backing plates for cast iron drums have an inner "lip" that can be very thin (that bends and rusts) or they can be thick. The thick lip wouldn't allow the aluminum drum to turn, on one of my CRXs. The thin lip needed just a little straightening with needle nose pliers. And just a couple of miles of rubbing wore any remaining bends.
That is what I experienced as well. Straightened out the lip where there was dings and pushed it on. I did this years ago but I do recall on side sliding on more easily then the other. Then I turned it back and forth until it turned with less drag. Drove it a few miles pulled the drums off and they slide right on. Basically same experience as you had. In my opinion it was much easier than changing the backing plates.
i have never had much luck getting the parking brake cable out of them, even with the special tool that still doesn’t seem to work.
Victor
86 K24 Powered CRX SI (SMF Solo2, HPDE-4 NASA & TA-A Time Attack
85 CRX DX totally original
07 Harley FXST Softail
2021 Tacoma Tow/Daily