- Red Pepper Racing
- → z6crx's Content
z6crx's Content
There have been 5 items by z6crx (Search limited from 29-April 23)
#360036 H22a In A 1g Crx
Posted by z6crx on 06 November 2007 - 11:24 PM in Swaps
http://hondaswap.com...a-tranny-94540/
Heres where i have the bracket for sale on Hondaswap
http://hondaswap.com...p...812&cat=500
and the 2G Crx it was in.
Sorry I keep procrastinating on getting any measurements. But I'm not completely sure If any measurement is going to help out from my chassis other than ones from the engine.
I had both the B16A and the H22 side by side.
I didn't physically measure but was just as wide and just a little bit taller.
Heres where i have the bracket for sale on Hondaswap
http://hondaswap.com...p...812&cat=500
and the 2G Crx it was in.
Sorry I keep procrastinating on getting any measurements. But I'm not completely sure If any measurement is going to help out from my chassis other than ones from the engine.
I had both the B16A and the H22 side by side.
I didn't physically measure but was just as wide and just a little bit taller.
#359077 H22a In A 1g Crx
Posted by z6crx on 29 October 2007 - 10:40 AM in Swaps
QUOTE (twilightprotege @ Oct 26 2007, 06:17 AM) <{POST_SNAPBACK}>
z6crx - is the h2b kit used?
yes, it is used and currently sitting on an H22a. It does come with the some extra parts, like an aluminum flywheel and a alternator relocation bracket. I'm in central PA if that helps you out any if you want to check it out. Then again I just looked you're in Australia, that may be a bit of a pain to complete any transaction.
Regardless, this should be an interesting thread to watch.
#358539 H22a In A 1g Crx
Posted by z6crx on 24 October 2007 - 09:09 PM in Swaps
QUOTE (twilightprotege @ Oct 23 2007, 07:41 AM) <{POST_SNAPBACK}>
the h22a will be boosted
can someone measure the width at the top of the block of a b-series motor for me? my h22a head is coming off tomorrow so i can measure the h22a then
can someone measure the width at the top of the block of a b-series motor for me? my h22a head is coming off tomorrow so i can measure the h22a then
I can get you a measurement tomorrow morning. I also have an H2B Kit for sale on hondaswap under z6crx as well. A friend just referred me over to this. So I just made a name and posted. I was actually considering trying to jam it into a 1G myself but currently do not have the time or resources to try this myself
an H22 into a 1g Crx would be awesome.
From what I know, notching the inside of the framerail is required on the 2G Crx unless you have an aftermarket crank pulley. So i would assume the block with the plate s about an inch or so wider. The plate is about 1/2" thick if you're wondering, but i can get you the actual measurements soon along with which measure with the chassis frame rail if i can get it.
- Red Pepper Racing
- → z6crx's Content
- Board rules
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing