Sign In
Create Account
like a mid 10 compression in the block instead of the stock pistons any info would help
Edited by palmeref9, 01 October 2003 - 04:59 PM.
0
Looking For D16a1 Parts
Started by palmeref9, Sep 30 2003 06:18 PM
2 replies to this topic
#1
Posted 30 September 2003 - 06:18 PM
-
- Granny
-
- Group: Members
- Location:sinanasty , oh
-
Drives: 86 crx 91 hatch
was wonding who sells after market pistions for a 88 d16a1or cams, etc.... i want to go
like a mid 10 compression in the block instead of the stock pistons any info would help
like a mid 10 compression in the block instead of the stock pistons any info would help
Back to top
#2
Posted 01 October 2003 - 04:59 PM
-
- Granny
-
- Group: Members
- Location:sinanasty , oh
-
Drives: 86 crx 91 hatch
#3
Guest_-TJ_*
Posted 01 October 2003 - 05:16 PM
Guest_-TJ_*
-
- Group: Guests
I bought pistons and rods for my D16A1 through Larry at www.theoldone.com (look under components for the pistons), AKA Endyn. I got the "ZC" pistons.
If you run zero piston to deck clearance with the high CR pistons he offers you will make close to 12:1 CR. If you just bore & hone the block for the same pistons, they sit about .035" in the hole and I believe the CR is 10.5? You'd have to do the math. As I remember, Larry lists the cc volume of each piston they offer.
-TJ
If you run zero piston to deck clearance with the high CR pistons he offers you will make close to 12:1 CR. If you just bore & hone the block for the same pistons, they sit about .035" in the hole and I believe the CR is 10.5? You'd have to do the math. As I remember, Larry lists the cc volume of each piston they offer.
-TJ
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing