odzfab

Made progress on the new engine harness. 90% k series harness with a few b series sensors.

Did some work on the motor.. Realized the one I first posted is another motor I'm building(mugen valve cover was mine) I just got a new type r red valve cover. Made a cam trigger to run kpro(project I'm building) new timing covers and misc seals.

That rear kit says 88+ wich is a different rear trailing arm. I'm sure it could work with some adjustments but the price ..... Eh.

Did you get them? Anyone install them? I wanted to do disk rear but I do not want to do the integra axle for a couple of reason. First I have a lot of work done to my axle for the fully adjustable panhard bar system I have on it. Secondly I do not want to widen the rear track width. That would increase traction in the rear which is not where these cars need it in the turns.

no need for the whole axle. All parts fit your existing axle . Yes it makes it what, a 1/4 inch wider per side. That's hardly noticible.