Take a mini da and sand smooth
The switch panel set in place
The main board mounted up and switch panel temporarily held in place until final paint. It will be glued in after paint is finished
Installed and programmed.
Now I just need to let it shrink up for a while before priming and painting
- Red Pepper Racing
- → Viewing Profile: Posts: k24 rd6
Community Stats
- Group Members
- Active Posts 17
- Profile Views 3897
- Member Title Slowpoke
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Not Telling
-
Location
Riverside, Ca
Previous Fields
-
Drives
2002 CR-V/1991 Integra/90 Accord/87CRX
0
Neutral
User Tools
Friends
k24 rd6 hasn't added any friends yet.
Latest Visitors
Posts I've Made
In Topic: Honda Homelink Retrofit
05 June 2011 - 10:22 PM
In Topic: Oem Honda Navigation
05 June 2011 - 08:22 PM
Cruise is easy. A few parts and a day or two
In Topic: Oem Honda Navigation
05 June 2011 - 12:59 AM
The viewing angle isn't great but I am tall and lean the seat back and it seems like it will be acceptable. I have driven yet but I if I need to, I can lower and angle down a bit to make it better. I wish there was a contrast control to help out.
It took about 3 hrs to mount the display but that is with wood. It would have been quicker with metal. The wiring harness is how it was in my accord, just plugged it into radio harness to test. It will take a couple days to rewire cleanly
No its not my dd.
Yes, I like to play with wiring very much
It took about 3 hrs to mount the display but that is with wood. It would have been quicker with metal. The wiring harness is how it was in my accord, just plugged it into radio harness to test. It will take a couple days to rewire cleanly
No its not my dd.
Yes, I like to play with wiring very much
In Topic: Glove Box Light
04 June 2011 - 12:05 PM
first gen. I got it from an 88 5 door LS
In Topic: Variable Intermittent Wipers Conversion
04 June 2011 - 12:42 AM
I can see adding a relay to ground the motor while the washer is on to bypass the intermittent. A trailing edge timer could delay the relay to keep the motor going for a short time after the washer stops.
A leading edge timer could be used to run the motor continually for a specified time when the wiper is first switched on before switching over to intermittent.
A leading edge timer could be used to run the motor continually for a specified time when the wiper is first switched on before switching over to intermittent.
- Red Pepper Racing
- → Viewing Profile: Posts: k24 rd6
- Board rules
Community Forum Software by IP.Board
Licensed to: Red Pepper Racing