Jump to content




Help! Crx Dying After Camshaft Install

Started by J-MAN, Nov 17 2009 11:26 PM

  • You cannot reply to this topic
91 replies to this topic

#91
Rampage
Posted 22 April 2010 - 01:27 PM

  • I bleed motor oil.
  • PipPipPipPipPipPip
    • Group: Moderators
    • Location:Vancouver, British Columbia
    • Drives: The Si (86 Civic Si D16A1 blacktop) The Blackbird (87 CRX Si Bone Stock) Cherry II (86 Civic 1500S Mostly Stock)
    • Image Gallery
    Garage View Garage
QUOTE (Lymitliss @ Apr 21 2010, 06:59 PM) <{POST_SNAPBACK}>
Tighten that cam gear down good!


On any critical bolts (cam gear, crank pulley, caliper adaptors, rear axle bolts) I always use a small amount of blue threadlocker to ensure the bolt will not move.

Just as important as proper torque!

Cheers,
Mark

SportInjectedClub

I don't frequent the boards much anymore, but i'm a wealth of knowledge. Email or PM me if you're stumped!

#92
Lymitliss
Posted 23 April 2010 - 01:05 PM

  • King Luke
  • PipPipPipPipPip
    • Group: 2012 Contributor
    • Location:Seattle, Wa
    • Drives: 1986 CRX Si B18C1, 1973 240Z V8 Conversion
    Garage View Garage
Oh I slather that stuff on all my bolts!
Build Thread- Here

Back to 1G CRX


  1. Red Pepper Racing
  2. → 1G Honda CRX/3G Honda Civic
  3. → Technical
  4. → 1G CRX
  5. Board rules