26 replies to this topic

[MakDiesel]

I decided to make a "Parts requested" list for those who are going to Bryman's 10/21-10/2? meet in NC. This way if you have some stuff laying around that you want gone and see it on this list, bring it to the meet and save us all on shipping. Likewise, if you want some shipping-free parts to show up at the meet, post it here and hopefully your request will be seen and accounted for. I'll start...


WTB:
1. 1 set of '85 CRX Si (and other fitting models) brake pad shims (4) (If I don't get them this time I'll just do without)
2. 1 set of '85 CRX Si (and other fitting models) brake pad springs (2)
3. A/C delete duct (to replace where the evaporator goes...it's just a hollow piece of plastic)
4. Full-length rear-view mirror
5. Quality full-sweep electric gauges (oil psi, water temp, and/or volts)
6. I'll think of more later....

Stuff I have to bring, if necessary:
1. an extra gas cap
2. Entire A/C system that works (Altho it is still in the car...Bryman has dibs)
3. misc. owners manuals (a few for 1g/3g alike + an '83 Datsun 280zx one) ~$10-15
4. 1986 CRX/Si service manual (will only trade for an '85 CRX Si one)
5. 80% of my blue interior (everything but the dash, seats, and door panels)
*****ADDED*****
6. New-in-the-box never installed Autogage trio gauge pod (water temp., oil psi., and amps) comes with senders ~$25
7. Hood latch cable and pull handle
8. My enormous, white, Autotek "Mean Machine" Amp that to this day hasn't been hooked to a system it couldn't blow if it was dialed up. 1800W, 50x2 (known as a "Cheater amp" b/c in stereo competitions it can be entered in the 100 watt and below class) can be dialed down to a .25 Ohm if I remember. Believe me, if you've seen it, you can feel it's power. ~$500 at the meet
9. 2 '96-00? Mustang GT/Thunderbird front calipers that some jackhole on ebay advertised as 92-95 Civic Dx calipers, then refused my refund. ~Someone please buy these, they have been in the shipping box as my doorstop for almost a year now
*****More ADDED 10-21*****
10. Assorted 280zx/240z parts (hood louves, valve cover gasket, Haynes and Chilton manuals, etc)
11. Stock air box w/ resonator chamber and decent filter (CRX Si models)
12. PCV valve, brand new
13. 120 MPH speedo, good condition, reads 19x,xxx miles
14. Passenger side mirror w/ interior plate and screws
15. Complete set of mudflaps, fair condition, not sure it they fit 3g Civic's or 1g CRX's
16. "How to Tune your Honda" book, printed in 1978. (for all you CVCC guys.)
17. Yes this all is in my car, it was 3 hours of cleaning and stacking...I don't want to return home w/ most of it, so any/all offers considered on anything, especially those GD calipers.


So whatever you want to show up at the meet, post here! Mak

Edited by MakDiesel, 21 October 2005 - 12:02 AM.

[E-AT_me]

uh, isn't it the 22nd?

i want anything for an 88-91 DX 4 door!! axles, clutch, anything!!

[down4ce]

I now need 1 torsion bar for an 86 crx hf or wagovan and a gas cap

[bryman10]

uh, isn't it the 22nd?

i want anything for an 88-91 DX 4 door!! axles, clutch, anything!!

<{POST_SNAPBACK}>

Yes, it's actually Oct. 21-23 (for whomever wants to show up friday night)


bryman

[mep]

I have several sets of 185/60-13 Yoko A048 road race/auto-x tires, all with 80-90% tread depth remaining, no damage, no uneven wear... maybe I'll bring a set of those.

I also have an 87 Si HB for parts, but I haven't had time to rogue what I want yet! If anyone needs a part, please drop me a line...

i want anything for an 88-91 DX 4 door!! axles, clutch, anything!!

<{POST_SNAPBACK}>

I'm parting some stuff from my 91 DX sedan with a D16Z6 swap. I have a nice low-miles JDM cable tranny installed on the car with probably 5k on the exedy clutch. PM me with what you really need the most, & maybe we can work something out.

I hope to to do some bartering at the meet this weekend

*I forgot that I told my uncle I would try to sell a Sparco seat for him... It's light grey with black accents, adjustable back, no sliders, really nice condition with a few small unnoticeable blemishes... I have plenty of pics if needed. He needs $175 for it.

Edited by mep, 17 October 2005 - 08:18 PM.

[ChrisF-dude]

How much you want for the 83 Datsun 280ZX owners manual? I'm not going, but may have Will pick it up for me. I used to have an old 280ZX. Heh, and you guys think CRXs are rusty!

[kedwards]

Items I can bring to bryman's:
CRX rear speaker covers and brackets (black)
HF instrument cluster
86-87 CRX passenger headlight
86-87 CRX corner lenses
CRX mud flaps. I have 2 rears and 1 front from an ‘85
’86-’87 CRX Si console
Civic Si/Integra SE sunroof deflector, with factory storage bag
I might part with a Wagonvan cargo cover
CRX Honda rear louver (might sell?)

Wanted:
Front strut bar
Rear strut bar
Rear swaybar
13X6 alloy wheels
Other parts suitable for my road racing CRX

My preference would be to swap parts, instead of selling.

mep, do you have a good LF fender on the 91 sedan? What color?

Keith, whose travel itinerary is up in the air for this weekend, though I *will* be there...

[BigOrange]

A known good Si transmission would be awesome... if you have one and you are going to brymans PM me and we can work out a deal of some sort.. I am in dire need of one.. thanks...

Edited by BigOrange, 18 October 2005 - 10:05 PM.

[MakDiesel]

How much you want for the 83 Datsun 280ZX owners manual? I'm not going, but may have Will pick it up for me. I used to have an old 280ZX. Heh, and you guys think CRXs are rusty!

<{POST_SNAPBACK}>

Oh man the horror stories I have of my '81 280zx...Epic rust in the rear quarters, fist-sized holes in the floors, frame rails rusted holy through...I'm surprised that car didn't split apart the last year I had it. Mechanically sound as any old Jap car (rivaling Honda/Toyota IMO) but the rust/neglect would eat these cars from the inside out 3x faster than any CRX rust. Anyway, a quick look on Ebay/gay shows the prices for one of these manuals anywhere from $20-75! That's rather high so I'll ask $15 (half what I paid 3 years ago...20+ yr old car books seem to be disappearing by the day) it's one of the last remaining pieces of her (besides a side emblem, radio, trim, etc) that wasn't taken from oxidation and metal rot. It's mint w/ all pages intact and just some random print marks on the covers from where it was in the glove box for so long (but the entire book is still very clear and legible throughout.) Tell me if that's fair. Sorry you won't be coming to the meet, the last (and much smaller) one last April was a great experience. Mak

Edited by MakDiesel, 19 October 2005 - 12:06 AM.

[kedwards]

A known good Si transmission would be awesome... if you have one and you are going to brymans PM me and we can work out a deal of some sort.. I am in dire need of one.. thanks...

<{POST_SNAPBACK}>

I don't have a spare Si tranny. I do have an early Integra tranny I can spare.

I have a radio delete plate and an A/C delete (cover for the switch hole).

I might be able to bring my newly designed Panhard rod reinforment system. I had two of them made (I installed the other on the race car Saturday.).

I think I have a complete dealer-installed roof rack. I removed it from a Wagovan.

[Screech]

WTT (maybe WTB):
Civic Si sunroof accesories
larger T-Bars
adjustible rear springs
adjustible struts/shocks
crank pully tools for b20/f23 engines
clutch alignment tool for S1 Cable tranny
replacement bushing for Hasport rear mount

Things I've loaded in the car already:
Si cluster (Denso)
HF cluster (Denso)
86 Si ECU
86 Si axles
86 Civic AM/FM cassette
99 Accord AM/FM cassette (greenish illum)
99 CR-V AM/FM cassette (orangish illum)
86 Si distributer, wires, coil.
EW4 Eng (25x,xxx miles, don't know if rebuilt, ran great when I pulled it)
GW Si Tranny (2nd or 3rd was starting to actup on occation)
86 Si airbox
86 Si Combo Switch
86 Si column covers.

Edited by Screech, 21 October 2005 - 09:42 PM.

[mep]

mep, do you have a good LF fender on the 91 sedan?  What color?

<{POST_SNAPBACK}>

It's red, but it's probably too dinged up & faded to even be worth pulling off

....

Here's the 185/60-13 Yokohm Advan A-048s I need to sell... PM for details.

http://www.cardomain.../ride/518479/19

Edited by mep, 19 October 2005 - 11:18 AM.

[E-AT_me]

i've got some 86 Si front calipers/pads/rotors.. pads and rotors are new..

[calmoc9]

interested in:

larger t- bars
rear shocks
coilover setup
intake tube
a hopped up cam
88-89 dist.
corner lenses
ignition switch and matching door locks & hatch locks w/keys
black 86-87 si door panels


dont have much to bring 'cept for an addition to the door prizes. rear "crx" panel.
and the seats.
the dreaded "leapard" door panel for ea-t me.

ill add more as it comes to me.


scott

Edited by calmoc9, 19 October 2005 - 03:44 PM.

[calmoc9]

i've got some 86 Si front calipers/pads/rotors.. pads and rotors are new..

<{POST_SNAPBACK}>

what kinda pads?



scott