Looking for a set to do a swap. Shipping is to zip 42101.
1G Integra Steering Knuckles
#1
Posted 13 February 2017 - 01:55 PM
#2
Posted 13 February 2017 - 09:38 PM
#3
Posted 13 February 2017 - 11:56 PM
#4
Posted 14 February 2017 - 01:27 PM
Cool - what is the intended use? Track car? DD? Drag? Just wondering if you should stay with the stock hubs?
#5
Posted 14 February 2017 - 06:26 PM
#6
Posted 15 February 2017 - 06:55 AM
I have a pair of early Integra steering knuckles with hubs. $75+ shipping.
Also a 5-speed and an automatic jack-shaft, not that I know which is which. I have knuckles and jack-shaft from a 4WD Wagovan, as well.
Lots of other parts http://www.redpepper...ic=37758&page=3
Keith A. Edwards
Suffolk, VA
1.75 1st gen. CRXs
former ECHC H5 Champion
#7
Posted 15 February 2017 - 02:49 PM
I have a pair of early Integra steering knuckles with hubs. $75+ shipping.
Also a 5-speed and an automatic jack-shaft, not that I know which is which. I have knuckles and jack-shaft from a 4WD Wagovan, as well.
Lots of other parts http://www.redpepper...ic=37758&page=3
Hey I tried to ask you about parts and it says you can't receive any messages!
#8
Posted 15 February 2017 - 04:42 PM
Sorry. I had to clean out some messages, from 2004...
Keith A. Edwards
Suffolk, VA
1.75 1st gen. CRXs
former ECHC H5 Champion
#9
Posted 16 February 2017 - 06:19 PM
#10
Posted 16 February 2017 - 06:45 PM
OK sent you a message... BTW when you say early integra you mean the 86-89 correct?
Yes. Pulled them off the shelf and took pictures today. Will upload them shortly. I notice they still have halfshafts, rotors, and calipers attached.
Keith A. Edwards
Suffolk, VA
1.75 1st gen. CRXs
former ECHC H5 Champion
#11
Posted 10 March 2017 - 08:33 AM
I live in England so parts over here are extremely rare and pretty much nothing ever comes up as not a lot survived the weather and the numerous scrap insensitives so I've had to think outside the box with my build not only with knuckles but the fuel system brakes etc etc
I made my original knuckles work , with 2mm machined off the face and the backs milled out and with 4G hubs pressed in to new bearings I have something that works just as good if not better then the aged old 1g teg knuckle swap , so if all else fails you can always do what I did , something will more the likey pop up tho beings you live over the pond just thought I'd add my 2 cents. Good luck with your build anyways buddy
- gtpilot likes this
#12
Posted 24 October 2017 - 03:06 PM
#13
Posted 03 February 2018 - 01:02 PM
#14
Posted 05 February 2018 - 04:03 PM
If you have Civic knuckles you could just put new hubs and bearings into them rather than looking for used Integra parts and hoping the bearings are still good.
https://www.ebay.com...119.m1438.l2649