1 reply to this topic

[JerBear]

Hey guys, I have the front end apart and on jack stands, I just replaced the boots on the steering rack and I'm moving to do all the Suspension. My question is, I pulled the rotor off the front and am curious if I have to pull the hub to remove the lug studs. It's about an inch between the lug stud and the "hub." So any "easy" way to replace these? Thanks, Jeremy

 

 

[PowerWheels86]

Unfortunately you do have to remove the hub from the knuckle, requiring a press... Most shops will knock this out for you for a nominal fee... And while you have them separated, I'd recommend having new bearings pressed in as well...