2 replies to this topic

[I Like Dry Toast]

I'm going to fit the larger spindles to a 1984 CRX.

 

Looking for the larger spindles that came on the 85-87 cars.

Should be 1.12"

 

Not looking for the smaller spindles that came on the 1984 cars.

Those spindles are 0.984"

 

Also need all the brackets, linkage, and bearings off the right side for the sway bar.

 

Thanks,

Tom

[86hatchie]

Tom,

 

I'm parting an 88 Integra and have all those items.  I'm fairly sure what I have would work.  I have the entire backend (minus the brakes) to breakdown.

 

Let me know if interested.

 

Tim

[I Like Dry Toast]

Thanks for responding.

 

I thought of including the Integra parts but they have different P/Ns for the Hub/Bearing.

 

The dimensions from the parts books seem the same in most respects with the one difference being the width of the bearings.

 

Offsets, and flange diameters, are the same.  The bearing ID is called out as 1.124" on the Integra and 1.12" on the Civic.  Is it really .004" different?  I doubt it.  The parts books just have to get these numbers pretty close for most purposes.

 

Will this spindle give the car a wider or narrower track?  I don't know.  Do you?  Has anyone done this particular swap?

 

What the heck.  I'll give it a try.  Let's do this.

 

Tried to PM you.  It says you can't receive anymore messages.  Full inbox?

 

Thanks,

Tom

 

BTW, I listed the size in the original post as 1.21".  That was wrong.  The dimension is really 1.12".  Sorry if that confused anyone.