Jump to content




CRX86Balla

Member Since 13 Nov 2012
Offline Last Active Sep 27 2014 09:28 AM
-----

Posts I've Made

In Topic: First Gen Radiators

27 July 2013 - 11:41 PM

I bought one of the Ron Davis radiators and its a work of art I must say. Granted it does cost a pretty penny to have it but well worth it in my opinion

I've seen those, Never really used them though cause I wasn't sure if they'd fit.. I'll probably go with that once I get the cash. Which one did you happen to get? 


In Topic: First Gen Radiators

24 July 2013 - 09:29 AM

Auto zone.. Orileys... Single cores for 120$

 cool thanks :D


In Topic: First Gen Radiators

22 July 2013 - 02:21 AM

Rock auto may have one, other wise most go with the 92-00 radiators or you could go with Heel Toe's stock fitting high performance radiator.


where could i find either of those?


In Topic: Selling This Pos

10 July 2013 - 01:01 PM

It does sounds like an air leak.  I'd get a spray can of something (sea foam or maybe a gel cleaner) that you can spray in isolated spots around the carb to find the leak.  Spray in small areas so it's easier to tell where the leak could be.  Obviously if you spray an area and the idle changes, you'll have an idea where to look.  I'd also go over the entire intake.  Good luck!

Thank you! I found the problem. Gotta get new hoses :) 


In Topic: Selling This Pos

10 July 2013 - 11:28 AM

I've never worked on this motor, but it looks like your plug wires have been either cleaned or replaced recently...  are they connected properly? It looks like you have them connected to the distributor (from back to front) 2, 1, 3, 4.  Is this correct?  

Got the not starting issue fixed but my engine is literally screaming and it's running rich. It was doing this before the valve cover gasket was installed. Sounds somewhat like an air leak is there as well. Any ideas?