33 replies to this topic

[CSPCRX]

Did you have to modify the section from the 2nd Gen that goes over the axle, excluding flanges?  From the pictures I can’t tell if you had to section it or modify it to work.

 

looking at building the exhaust for my CRX and Trubends sells a 3in pipe only kit for the 2nd gen that I was thinking I could modify to work especially if the section over the axle works.

[Dear_Boss]

There were a couple very simple modifications i had to make to it.

 

- I shortened the rear straight section a few inches just to be able to fit my muffler where i wanted it. 

- I moved the exhaust hanger so it lined up with the factory 85' location

- Lastly i had to weld on an adapter to go from 1.75" to 2" which is what the muffler needed.

 

So yea i had to modify it but they are all really simple modification and made not even be necessary for what you are going to do with it.

 

If you need some more pictures or something just let me know.

[CSPCRX]

Thanks that’s good news.  Two of those I would not have to do since the tubes don’t have hangers mounted or need the adapter.

 

thinking it might just be the solution!

 

thanks again

[Dear_Boss]

No problem, im sure it will work out fine.