Jump to content




87 Crx With B18C1 Swap. Will Obx Itb Fit?


  • You cannot reply to this topic
1 reply to this topic

#1
jc55

  • Granny
  • Pip
    • Group: Members
    • Drives: 1988 Integra

Hello, does anyone know if the OBX ITB on a B18C1 will fit in an 87 crx? I've seen that the gsr manifold doesnt really have any clearance



#2
CSPCRX

Not sure. If it’s about the same size as the stock plenum or ITR/CTR plenum is I don’t see why not.They should be able to give you measurements if you call. Big challenge will be swapping it as you have to pull it out enough to clear the studs. When I switched out my JG / Edelbrock I had to remove trans mout and get some tilt on the motor.


Victor
86 K24 Powered CRX SI (SMF Solo2, HPDE-4 NASA & TA-A Time Attack

85 CRX DX totally original
07 Harley FXST Softail

2021 Tacoma Tow/Daily