9 replies to this topic

[T-REX]

Swap is done minus the axles...And vac lines, I miss my baby and I need help... Don't know what I need for axles so if you are not sure please don't post here... If you do please let me know as the first gens are a new to me. I have two 91's and the 87 and I think it is my favorite so I built it. Did swap plus t/3 turbo, intercooler, blitz bv and timer custom pan and all alum. powder coated pipes... Please help I miss it...


MOTOR IS D16A1 BLACKTOP AND CAR IS 87' CRX Si
Which axles do I need or which pieces...PLEASE BE MAKE, MODEL AND YEAR SPECIFIC...THANKS EVERYONE

Edited by T-REX, 10 November 2005 - 02:57 AM.

[JEFFtheJ00la]

as mentioned in many many posts and the faq, you need....dum da da dum....86-89 integra axles and knuckles

[T-REX]

as mentioned in many many posts and the faq, you need....dum da da dum....86-89 integra axles and knuckles

<{POST_SNAPBACK}>

So I need the complete axle and hub (knuckle)??? Not being a smartass I am just making sure...Thanks...

[JEFFtheJ00la]

yep. and you are aware that the integra has a 3 piece axle...so you need the two outer axles and the intermediate shaft

[T-REX]

yep. and you are aware that the integra has a 3 piece axle...so you need the two outer axles and the intermediate shaft

<{POST_SNAPBACK}>

You are a life saver...With these axles all I have to do is install and go, or do I have to add/subtract anything such as brackets, braces etc???

[JEFFtheJ00la]

bolt them on and your ready to go.

[T-REX]

bolt them on and your ready to go.

<{POST_SNAPBACK}>

For a small moment in time, you got to be my hero...THANX A SHITLOAD
I'll add you to friends list if you don't mind and when it's done I'll send pics.

[JEFFtheJ00la]

sweet. cant wait to see it, sounds like a bad ass set up

[T-REX]

sweet. cant wait to see it, sounds like a bad ass set up

<{POST_SNAPBACK}>

It ran 11.2 in my 87 hatch, Now motor is rebuilt by a very trusted machinist with some more goodies and a little more psi, Should prove to be my baddest one yet...
Thanx again and I'll be back tom. night

[boman]

Or, to retain your CRX knuckles you can make some Hybrid axles;


It's completely plug and play...

Here is what you need;

2 x Passenger side CRX/Civic axles
2 x Integra axles

You are going to use the stock axles and outers and swap in the teggy
inners. Just pull off the inner boots and swap over the ends -- it's that
easy.

The carbed ZC car has had this setup and it ran problem free for 2 years. The
car was driven very hard (cuz that ZC HAULED ASS) and there was no problems
with the axles! This is by far a cheaper and easer route than swapping the Integra
knuckles.

** However, if you are planning to do a teggy big brake swap you might aswell
just swap the teggy knuckles to save you a headache down the road.

hope this helps --> Now go join the DOHC side.

j