Hello, does anyone know if the OBX ITB on a B18C1 will fit in an 87 crx? I've seen that the gsr manifold doesnt really have any clearance
0
87 Crx With B18C1 Swap. Will Obx Itb Fit?
Started by jc55, Jun 20 2020 05:16 PM
1 reply to this topic
#1
Posted 20 June 2020 - 05:16 PM
#2
Posted 21 June 2020 - 04:13 PM
Not sure. If it’s about the same size as the stock plenum or ITR/CTR plenum is I don’t see why not.They should be able to give you measurements if you call. Big challenge will be swapping it as you have to pull it out enough to clear the studs. When I switched out my JG / Edelbrock I had to remove trans mout and get some tilt on the motor.
Victor
86 K24 Powered CRX SI (SMF Solo2, HPDE-4 NASA & TA-A Time Attack
85 CRX DX totally original
07 Harley FXST Softail
2021 Tacoma Tow/Daily