0
1.5l Block. And Drivers Side Plastics.
Started by nonnef, May 19 2011 10:49 PM
4 replies to this topic
#1
Posted 19 May 2011 - 10:49 PM
Need a block that doesn't need bored out. Either an EW or D15, just so long as its not an HF or a 1.3 I'm not picky. Or even a full motor or short block is good.
I'm just tired of part hunting for this HF I have. DXs are so much easier to find things for.
Also need plastics for an 87 Non-SI CRX. Mostly drivers side, but all around backups are needed.
I'll be headed up the east coast at the end of the month, so anything on my way is preferred and I could do a pickup and pay cash. Dont mind driving out of the way a few hours, but no California detours.
#2
Posted 19 May 2011 - 10:51 PM
#3
Posted 22 May 2011 - 01:14 PM
QUOTE (JEA86 @ May 19 2011, 11:51 PM) <{POST_SNAPBACK}>
d16 swap? lol
If I can find the rest of the stuff I need, sure, I'd take that motor off your hands. Otherwise I just need a block.
Still looking, no one has anything?
#4
Posted 22 May 2011 - 11:00 PM
I have a block sitting on the floor. Good to go.
#5
Posted 23 May 2011 - 07:50 AM
QUOTE (Maine_Honda_Racer @ May 23 2011, 12:00 AM) <{POST_SNAPBACK}>
I have a block sitting on the floor. Good to go.
Pmed.