Jump to content




naddiev

Member Since 11 Mar 2004
Offline Last Active Nov 01 2004 12:55 AM
-----

Posts I've Made

In Topic: Overheating Please Help

01 November 2004 - 12:40 AM

well found head cracked sad.gif

In Topic: Overheating Please Help

10 October 2004 - 09:01 PM

Earlier today replaced water pump and changed the oil. I bled and burped water system, started right up as always. I left the cap off to see what was going on and water rose a bit the whole time and then after about 10-15 minutes started getting air bubbles coming out of radiator, so i then placed cap on. gauge got to about 7/8 then i shut it off.

gonna recheck head gasket again this week

i have replaced everything in the cooling system that i know to do.

what is chances of block or head ??

again any help would be greatly appreciated

Thanks
Jeff

BTW anyone near Augusta GA ??

In Topic: Overheating Please Help

09 October 2004 - 07:56 PM

ok gonna replace the water pump tomorrow and change the oil

In Topic: Overheating Please Help

04 October 2004 - 08:15 PM

yeahi have checked timing with a gun, i had had the idle a bit high, its now at aprox 800 and timing is at center mark of the three marks on pulley, it also advances when i rev.

do the blocks ever have any problems ? or is that unlikely ?

i attempted to burb system by squeezing hoses and got alot of air.

when i pulled the water pump the blades looked ok.

i have replaced the thermostat, radiator, cap, upper and lower hoses.

thank you everyone for all the replies, i really wanna get this car running so i can let the wife have her car back.

In Topic: Overheating Please Help

03 October 2004 - 09:57 PM

this morning i burped coolant and adjusted idle and timing came right into place, ran at idle for about 25 minutes and gauge got to about 3/4 sad.gif

any extra input ??

thank again
Jeff