Jump to content

87 Crx With B18C1 Swap. Will Obx Itb Fit?

  • You cannot reply to this topic
1 reply to this topic


  • Granny
  • Pip
    • Group: Members
    • Drives: 1988 Integra

Hello, does anyone know if the OBX ITB on a B18C1 will fit in an 87 crx? I've seen that the gsr manifold doesnt really have any clearance


  • Leadfoot
  • PipPipPipPipPip
    • Group: 2016 Contributor
    • Location:Phoenix AZ
    • Drives: B Powered 86 CRX SI, 2012 Audi S4, 07 Harley FXST Softail
    • Image Gallery
    Garage View Garage

Not sure. If it’s about the same size as the stock plenum or ITR/CTR plenum is I don’t see why not.They should be able to give you measurements if you call. Big challenge will be swapping it as you have to pull it out enough to clear the studs. When I switched out my JG / Edelbrock I had to remove trans mout and get some tilt on the motor.

86 B-Powered CRX SI (SMF Solo2, HPDE-4 NASA & TA-A Time Attack
07 Harley FXST Softail
12 Audi S4