QUOTE (hondaman23 @ Jan 31 2010, 07:43 AM) <{POST_SNAPBACK}>
Here is my set up on full race car:
27mm Torsion (never a need to go higher even with slicks)
450 lb springs on Coilovers
Suspension Techniques Bushings
Adjustable Panhard - My creation with Sperical Bearings
Stock Sway bar from Integra (I think, cant remember) or could be a CRX stock
Front Sway bar long gone. First thing to get taken off the car!!!!!!!
Koni Adjustable Sports (Yellows), shortened, revalved - A must for these cars! Not cheap though.....
Camber plates - My creation with Spherical bearings
D16A1 Turbo, Running 8 psi gets to 238 WHP on Mustang Calibrated Dyno - Sponsor Appalachian in Black Mtn, NC
Electromotive Engine Management, TecGT
I run this car @ VIR 130 mph+ and I run out of gear half way down straights. Here it is at CMP where I took 1st place, this is the picture from the trophy! And yes, that is slicks on rain!!!
This was a couple of years ago. I have since updated the whole front end of the car with different splitter set up and cooling.
27mm Torsion (never a need to go higher even with slicks)
450 lb springs on Coilovers
Suspension Techniques Bushings
Adjustable Panhard - My creation with Sperical Bearings
Stock Sway bar from Integra (I think, cant remember) or could be a CRX stock
Front Sway bar long gone. First thing to get taken off the car!!!!!!!
Koni Adjustable Sports (Yellows), shortened, revalved - A must for these cars! Not cheap though.....
Camber plates - My creation with Spherical bearings
D16A1 Turbo, Running 8 psi gets to 238 WHP on Mustang Calibrated Dyno - Sponsor Appalachian in Black Mtn, NC
Electromotive Engine Management, TecGT
I run this car @ VIR 130 mph+ and I run out of gear half way down straights. Here it is at CMP where I took 1st place, this is the picture from the trophy! And yes, that is slicks on rain!!!
This was a couple of years ago. I have since updated the whole front end of the car with different splitter set up and cooling.
I absolutely love the look of this car! THe great stance, the racing setup.I have an 87 I am preparing for autocross and am inspired by this car. My front air dam was missing and I made one that looks very much like the one in this picture.
I would love to have adjustable Koni shocks but they no longer make them for this car. I suspect the wheels shown are 13"? Keep up the great work. My car is silver but I may have to go with white after seeing this car.